M1C Sniper Garand
M1 Garand Derivatives and Copies
•
17m
The M1C was an M1 Garand with a telescopic sight, using a mounting system developed by the Griffin & Howe company of New York. It utilized a rail pinned and screwed to the left side of the receiver, coupled with a quick-release scope on top. The rails had to be installed prior to heat treating the receivers, which had the unfortunately consequence of preventing rifles form being chosen for sniper conversion based on their mechanical accuracy. Instead, accuracy would be tested only after rifles were complete, leading to a 60% rejection rate.
The scope was offset to the left of the receiver so as not to interfere with the Garand’s clip loading, and issued with a leather cheek pad to give the shooter’s cheek weld a matching offset to the left. The scope used with the M1C was the M73B1, later replaced with the M81 and M82 scopes - all military versions of the 2.5x Lyman Alaskan hunting scope (which was a very good piece of equipment despite its low magnification)
The M1C was adopted in 1944, but production and quality control delays would prevent it from seeing any action in WWII. It was in use during the Korean War, however, before being replaced by the M1D.
Up Next in M1 Garand Derivatives and Copies
-
M1D Garand Sniper
The M1D was the final adopted form of John Garands sniper M1 rifle, originally the M1E8. It was intended to be a kit issued in the field to add optical sights to any rifle deemed worthy, and retained that capability in a slightly different form than originally intended. Garland’s initial plan was...
-
Navy 7.62mm NATO Conversion M1 Garand...
When the M14 rifle was developed to replace the M1 Garand, is was met with some uncertainty by the US Navy. The Navy had a lot of things to spend money on, and not a lot of need for a replacement for the M1 Garand (note that the Marine Corps did adopt the M14 despite being a component of the Navy...
-
GX vs GY: What Are the Differences in...
In a last hopeful attempt to get a rifle adopted and produced for the US military, John Pedersen designed his own copy of the M1 Garand rifle in the late 1930s (approximately 1939). His toggle-locked rifles had been irreversibly rejected, and the Garand rifle fully adopted by 1936. Pedersen's exa...
